Seat Lock Operation/Seat Removal - Triumph DAYTONA 650 Manual

1. Front Seat Fixing Locations
SEAT LOCK
NOTE:
When delivered from the factory,
S
the motorcycle is supplied with a
rear seat and a rear cover. Either of
these separate parts may be fitted
according to rider preference.
The process for removal and
fitment of either the seat or cover
is the same.
Two seats, or a rider seat and rear cover can
be fitted to this motorcycle. Both can be
removed independently.
To remove the rider seat, gently push
forward on the rear of the seat pad in order
to expose the two seat fixings. Release the
fixings, lift the rear of the seat and slide it
rearwards to release it from the frame.
The rear seat/cover is secured by a
key-operated lock which is situated on the
left hand side of the motorcycle. To remove
the rear seat/cover, insert the ignition key
into the seat lock and turn the key
anti- -clockwise while pressing down on the
rear part of the seat/cover.
General Information
1. Rear seat/cover lock
To detach the rear seat/cover, lift the rear of
the seat/cover and slide it rearwards.
To refit the rider seat, engage the front
section of the seat to the fuel tank and
secure the rear with the two fixings. Tighten
the fixings to 9 Nm.
To refit the rear seat/cover, engage the front
section of the seat to the front of the space
provided and press down on the rear to
engage in the seat lock.
NOTE:
seat/cover during riding, after fitting
always grasp the seat/cover and pull
firmly upwards. If the seat/cover is
correctly secured in the lock, it will
not detach from the rear frame.
A loose or detached seat could cause
loss of motorcycle control and an
accident
Page 29
An audible 'click' can be heard
S
when the rear
correctly engaged in the lock.
WARNING:
detachment
!!
!
seat/cover is
To prevent
of the rear