Initial Auto Installation; Checking Signal Strength And Channel Strength - Sharp Aquos LC-32B20E Operation Manual

Quick guide

initial auto installation

When the TV powers on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.
Confirm the following before turning on
the power
E Is the antenna cable connected?
E Is the AC cord plugged in?
1
Press a on the TV.
• The initial auto installation wizard appears.
2
Setting the on-screen display language
English
Italiano
Svenska
Press a/b/c/d to select the desired language,
and then press oK.
3
Setting the country (Location of TV set screen)
Austria A B/G
Finland FIN B/G
Greece GR B/G
Press a/b/c/d to select your country or area,
and then press oK.
• The Location of TV set screen only appears during
the first installation.
4
Starting channel search
Digital Search
Press c/d to select "Digital Search" or "Analogue
Search", and then press oK.
• If you want to search for more broadcasts, execute
"Auto Installation" again from the Setup menu.
5
note
• If you turn off the power on the TV after performing step 4,
• The initial auto installation wizard will go off if you leave
If you install a DVB-T antenna for the first time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking the
antenna setup screen.
1
2
3
E
E
Analogue Search
4
note
• The values of "Signal Strength" and "Quality" indicate when
The TV searches for, sorts and stores all the
receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress, press
enD.
the initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the Setup menu. (Page 26)
the TV unattended for 30 minutes before searching for
channels in step 5.
Checking signal strength and
channel strength
Press menu and the menu screen displays.
Press c/d to select "Setup".
Press a/b to select "Antenna Setup-DIGITAL",
and then press oK.
Checking signal strength
Press a/b to select "Signal Strength".
Supply Voltage
Signal Strength
Channel Strength
CH No.
Signal Strength
Current
Quality
Current
Checking channel strength
Press a/b to select "Channel strength", and
then press oK.
• You can input a specified frequency band using 0 - 9
numeric buttons.
Supply Voltage
2 6 5
Signal Strength
Channel Strength
CH No.
Signal Strength
Current
Quality
Current
Position and align the antenna so that the
maximum possible values for "Signal Strength"
and "Quality" are obtained.
to check the appropriate alignment of the antenna.
21
0 Max. 0
0 Max. 0
. 2
MHz
21
0 Max. 0
0 Max. 0