Harman Stove Company HB 38 DV Installation And Operating Manual page 34

Only For Qualified Installers
Blower Assembly Ready to Install.
Blower Assembly Installed.
INSTALLATION (Options)
6. Place the blower assembly into the blower box.
7. Install finished flooring, carpet, tile, etc.
8. Install register by sliding it down into the
9. Turn on electrical power and test.
Operation:
Note: A temperature switch on the fireplace will
1. Open the speed control door and turn the blower
2. Close the speed control door.
Speed Control
Knob
34
You may need to tilt the assembly to get it
through the opening in the blower box. Make
sure the wires do not get pinched.
opening. Make sure the speed control door is
over the speed control. The register is designed
to allow for a variation in floor thickness.
not allow the register blower to start if the
fireplace is not warm enough to blow hot air.
This same switch will turn the blower off, if
the fireplace is turned off and cools.
on to the desired speed. Turning the blower on,
opens the damper in the top of the fireplace and
allows hot air to flow.
Under Floor View