Sharp XL-MP150H Operation Manual page 39

Sequential recording from several discs:
1 Perform steps 1 - 6 in "Recording from a CD or MP3/WMA disc"
on page 27.
2 Within 5 seconds, press the / (TAPE
side A, or the (TAPE ) button for side B.
To perform programmed recording:
1 Programme discs and tracks (see pages 18).
2 Press the button.
3 Press the / (TAPE ) button to record on side A, or the
(TAPE ) button for side B.
To stop recording:
Press the (TAPE ) button.
The disc and tape will stop.
Note:
To record on both sides, begin with side A. (If recording is started
from side B, the tape will not switch over to side A.)
Auto restart function:
If the recording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.
Recording from the radio
1
Tune in to the desired station (see page 23).
) button to record on
2
Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the
... To record on both sides.
... To record on only one
side.
4
Press the
Recording will be paused.
5
Press the
(TAPE
To record on both sides, begin with side A. (If recording is start-
ed from side B, the tape will not switch over to side A.)
To interrupt recording:
Press the
To resume recording, press the same recording button you pressed
in step 5. Other buttons do not allow resuming.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the
AM loop aerial.
Erasing recorded tapes
1 Press the TAPE button.
2 Follow steps 2 - 5 in "Recording from the radio".
button to choose one side or both sides.
button.
/ (TAPE ) button to record on side A, or the
) button for side B.
button.
XL-MP150H
ENGLISH
8
E-28