Dynacord PSD 215 Owner's Manual page 9

Illustration 2-7: Menu structure of the PSD
Main Menu
Preset Select
Preset Save
System Equalizer
System Alignment
DSP OUT Settings
Lock Device
Device Setup
Press the MENU/ENTER rotary encoder to open the Set
Preset Name dialog. This dialog is used to change the user
memory's description. Turn the MENU/ENTER rotary enco-
der to the left or right to edit the highlighted character.
Pressing the MENU/ENTER rotary encoder accepts the de-
sired symbol and moves the cursor to the next character.
Move the cursor to the left or to the right by pressing the
 
or function keys. Select the
function key to quit editing the name. Pressing the BACK
function key returns to the menu.
Illustration 2-8: Set Preset Name
Set Preset Name
D E F G H I J K
Delay Line 10m
S E
YSTEM QUALIZER
This dialog is used to edit the 6 band System Equalizer fil-
ter settings. Select a filter band (e.g. 160 Hz) by pressing
 
the or function keys.
PRESET
SUB Level:
INPUT SIGNAL: LOW
DSPOUT
Device Setup
Display Brightness
Display Auto Dim.
Delay Unit
Lock Level
Factory Reset
Firmware Info

symbol or press the OK
L M N O P Q R S T
OK BACK
TS 400-A
-42dB =
EQ PRESET ALIGN
DSP Out Settings
Level
Delay
Hi-Pass
Lo EQ
Hi EQ
Illustration 2-9: System Equalizer
System Equalizer
80 160 315
+10dB +5dB 0dB
Turn the MENU/ENTER rotary encoder to set the level amp-
lification (boost, accentuation) or reduction (cut,
lowering) of a band. The filter setting is illustrated by a
fader. Pressing the OK function key returns to the menu.
Pressing the FLAT function key resets all filter bands to
0dB.
S A
YSTEM LIGNMENT
This dialog allows to set up the basic speaker settings of
the PSD system. Turn the MENU/ENTER rotary encoder to
highlight an entry in the left column of the System
Alignment dialog. Press the MENU/ENTER rotary encoder
to select the corresponding value in the right column. Now
turn the MENU/ENTER rotary encoder to edit the value and
press the MENU/ENTER rotary encoder again to apply the
new value. The following table lists the entries of the
dialog, please also refer to the block diagram on page 25.
PSD 215 | 218
System Alignment
SYS Level
SYS Delay
SUB Delay
SUB Polarity
Generator
Testsignal
800 3.15K 10K
0dB +5dB +10dB
OK FLAT
9