Battery Charging - Golden Technologies Compass GP600 SS Owner's Manual

Compass Owner's Manual – Models: GP600 SS, GP600 CC
CHARGING THE BATTERIES
Your Compass's charging system is designed for your safety and for your convenience.
Follow the steps below to recharge the batteries.
1. Position your Compass
2. Turn off the power on the joystick.
3. Remove the charger from the SEAT POCKET. See figure 24.
4. Insert the matching charger plug into the joystick's charging socket that is located at
the front of the joystick. See figure 25.
NOTE: MAKE SURE THE STANDARD ELECTRICAL OUTLET YOU ARE USING IS NOT
CONTROLLED BY A LIGHT SWITCH CAUSING THE CHARGER TO SHUT OFF WHEN
IT IS ACTIVATED.
5. Insert the plug at the other end of the charger power cord into a standard electrical
wall outlet.
6. Disconnect the charger power cord from the wall outlet and from the joystick charging
socket when the batteries are fully charged.
NOTE: The batteries will be fully charged in approximately eight hours. A full charge is
indicated when the green light on the battery charger side panel turns on and all 8
joystick LEDs are lit when joystick is turned on.
Figure 24

BATTERY CHARGING

close to a standard wall electrical outlet.
™
Figure 25
31
Revised 05/23/13
Charging Socket