Built-In Installation - Smeg BQ90 S Instructions For The Installer

7.2 Built-in installation

After screwing the 4 feet supplied into place, the barbecue can be installed in compliance with the
dimensions supplied and the instructions below.
INSTALLATION GUIDELINES
A
A
A
Instructions for the Installer
C
B
A
C
B
A
C
B
A
INSTALLATION OPTIONS
BUILT-IN CLOSE TO INFLAMMABLE
SURFACES
"Inflammable surfaces" refers to wood,
plants, etc. For this installation, a gap of 50
mm must be left from the adjacent walls
(DISTANCE A) and 250 mm from the back
wall, if any (DISTANCE B).
The walls next to the barbecue must not
be taller than its work surface. (see
diagram).
Any top above the appliance must be at
least 1000 mm above the height of the
grids (DISTANCE C).
BUILT-IN CLOSE TO NON
INFLAMMABLE SURFACES
"Non inflammable surfaces" refers to
masonry or similar materials. A gap of at
least 25 mm must be left from any adjacent
walls on both sides (DISTANCE A) and
250 mm from a rear wall (DISTANCE B).
The walls next to the barbecue must not
be taller than its work surface. (see
diagram).
Any top above the appliance must be at
least 1000 mm above the height of the
grids (DISTANCE C).
Apart from ventilation requirements, the
gap between the appliance and any rear
wall is needed for the gas connection and
to allow the battery to be changed.
Smaller gaps may put the
structure and the user at risk.
The gas cylinder may be
accessed through a hole made
in the structure (taking care to
protect the edge of the hole to
avoid damaging the gas
connection hose) or by passing
the hose around the appliance.
In this case, take great care to
ensure that the hose does not
touch the product at any point
and is not suspended from the
grids.
:
33