Switching On - Smeg BQ90 S Instructions For The Installer

9.3 Switching on

To check that the burners inside the barbecue have ignited, hold one of your hands about 10 cm above
the grids: you should feel a gradually increasing amount of heat.
When lighting the ultra-rapid burner, keep the knob pressed down for about 5 seconds to allow the
thermocouple to heat up. The burner may go out when the knob is released: this means that the
thermocouple has not warmed up enough. Repeat the operation, keeping the knob pressed down for
longer.
If the burners have not ignited after several attempts, wait 5 minutes before attempting to light the
appliance again. This pause is necessary to allow any gas which has built up inside the appliance to
disperse. If no flame is obtained even after numerous attempts, contact your nearest authorised service
centre.
9.3.1 Electronic burner ignition
The burner it controls is shown next to each knob (see point "Control Panel" on page 15). To light the
flame, simply press the knob and turn it anti-clockwise to the minimum flame symbol
ignition button. To adjust the flame, turn the knob to the zone between the maximum (
minimum (
9.3.2 Manual burner ignition (for internal burners only)
The burner it controls is shown next to each knob ( see "The control panel"
on page 37).
Each model has holes in the sides (see right) to allow the burners to be lit
by hand.
To ignite the two side burners by hand, turn the knob to the highest setting
and place a lit match close to the ignition hole. The central burner can be lit
in manual mode from another burner: light the right or left-hand burner and
turn the central burner knob to the maximum setting. If the burner does not
light within 10/15 seconds, wait a few minutes and repeat the procedure.
If no spark appears when any burner control knob is pressed, the battery on the rear may need
changing.
For instructions for this procedure, see point "9.1 Fitting and changing the battery "
If the battery is new and still no spark is produced, do not attempt to use the appliance and contact your
nearest authorised service centre.
40
Instructions for the User
) settings. To turn off the burner, turn the knob back to the OFF position.
and press the
) and the