To Omit Zones - Texecom PREMIER 24 User Manual

Operating the Alarm System

To OMIT Zones

It is possible to exclude (omit) individual zones when arming i.e. if a zone is 'in fault'. Users
with access to this function can only omit zones that have been programmed as 'Omittable'.
!"
If the zone can be omitted, there will be a 'Star' to the right of the zone number.
Only zones that have the 'Omit' attribute assigned to them can be omitted.
A 'Star' will appear to the left of the zone number to indicate that the zone has been
selected for omitting.
All omitted zones will be automatically reinstated the next time the system is
disarmed, unless programmed otherwise.
To re-instate zones manually, simply follow the instructions again. However, when
the key is pressed on this occasion, the zones will be re-instated.
3
1. Enter a valid User code
2. Enter the zone number
3. Press to omit the selected zone
3
Repeat for other zones if required.
4. Press when finished
4
Continue to arm the system as normal.
The Turn CHIME On and Off
The system can be set up so that activating (opening) certain zones will cause the
internal sounders to chime. This would normally be used on a front door, exit button etc.
!"
Zones will only cause the internal sounders to chime if they are selected for chime
(see page Master User Guide for details on selecting which zones chime).
Once a zone has been selected for chime, the Chime facility can be manually turned on
and off as required.
!"
The system can also be programmed to automatically turn chime on and off under
certain conditions i.e. certain times of the day, door left open etc.
If no zones have been programmed for Chime, then turning Chime on and off will
have no effect.
To turn CHIME On
1. Press
The Chime tone will sound.
8
,,,,
,,,
-
Premier Series User Guide
and press
3
To turn CHIME Off
1. Press
The Error tone will sound.
-
INS221