Walk Test; Test Speakers & Outputs; Send Test Call; Enable Remote/Engineer Access - Texecom Premier 8SP User Manual

System Program Menus
From
Previous Page

Walk Test

The Walk Test feature can only be performed when the
system is disarmed. 24 hour zones (except Fire, Tamper and
Trouble) are disabled during Zone Test allowing Audible PA
buttons, Silent PA buttons, etc. to be tested.
Test Speakers & Outputs
This menu options allows you to perform the following tests:
# Test Speakers
$ Test Bells
% Test Strobes
( Test System Outputs
"
When performing the "Test System Outputs" option,
only outputs programmed by your installer will be
activated during this test.

Send Test Call

This menu options allows you to send a test call
transmission to your Alarm Receiving Centre.
"
If the test call is unsuccessful, the keypad will sound
an error tone.

Enable Remote/Engineer Access

Your alarm system may be configured in such a way that
you have to authorise Remote/Engineer Access. Once
authorised, your alarm system will allow:
•
Your installer/Alarm Receiving Centre to access the
alarm system via the remote downloading computer.
•
Your installer/engineer to access the control panel
programming menus.
The alarm system will allow access until 12.00am, after
which, both Download and Engineer Access will be denied.
18
Banner Text (LCD Only)
Press to edit text.

Print 100 Events

Exit Program Mode

'"
'#
'$
'%
Text Editing Keys
Use keys to enter/edit text.
Then press to accept.

Start Call Back

This option will cause the control panel to initiate a call back
sequence. This will allow the remote downloading computer
to remotely access the control panel.
"
You should only use this feature when requested by
your installer/Alarm Receiving Centre. If the Call Back
is unsuccessful the keypad will sound an error tone.

Program Time

The control panel has a real time clock that is used to date
and time stamp events that are recorded within the system
log. The option allows you to set the control panel time.
Program Date
The control panel has a real time clock that is used to date
and time stamp events that are recorded within the system
log. The option allows you to set the date on the control
panel.

Program Banner Text (LCD only)

If the system is fitted with a LCD remote keypad you can
assign up to 16 characters of text to the Banner Message.
The Banner Message is displayed on the top line of the LCD
display during the normal disarmed
programmed in a similar way to mobile phones. Characters
are selected by pressing the corresponding key the
appropriate number of times (to select a character on the
same key, press 6 to move the cursor along). For details
on entering text, see page 13.
Print 100 Events
If your system has a printer connected, this menu option
allows the last 100 events in the system Event Log to be
sent to the printer.
Exit Program Mode
Selecting this menu option will exit the programming mode
and return the system to its normal state.
Premier 8SP Master User Manual
. , ? ! 1 @ " - &
a b c 2 A B C
d e f 3 D E F
g h I 4 G H I
j k l 5 J K L
m n o 7 M N O
p q r s 7 P Q R S
t u v 8 T U V
w x y z 9 W X Y Z
Space 0 , # *
Move Left/Right
Backspace (delete)
'(
'&
')
'*,
state. Text is
'!,
'',
INS237