supplied by the USB port on some older computers is below the 5V DC required to
power the StoreJet 25. In this instance, please connect the spare large connector of the
provided USB Y cable to a second USB port on the computer, this will provide the
additional power necessary to run the drive.
Please use the Mini USB to USB A-Type cable that came with the StoreJet 25 to
•
connect it to a computer, and always ensure that the cable you are using is in good
condition. NEVER use a cable that is frayed or damaged.
Ensure nothing is resting on the USB cable and that the cable is not located where it can
•
be tripped over or stepped on.
If you have connected all ends of the USB cable and still have power-related problems
•
while reading / writing data, we recommend that you purchase a Transcend USB Power
Adapter (TS-PA2A) to provide the power necessary to operate the StoreJet 25.
Reminders
Always follow the procedures in the "Disconnecting from a Computer" section to
•
remove the StoreJet from your computer.
The spare USB connector can provide additional
power for the StoreJet 25 when needed
5