Table of Contents
Advertisement
Unhooking the door
Fully open the oven door.
1.
Remove both locking levers located on the right and left hand
2.
sides (figure A).
Fully close the oven door as far as possible (figure B). Grip
3.
the left and right hand sides of the door with both hands.
Close the door slightly more and remove it.
$
Hanging the door
Rehang the door by following the same steps but in reverse
order.
When refitting the door, check that both hinges are
1.
positioned exactly inside their respective openings (pictur A).
The bottom groove of the hinges must fit snugly on both
2.
sides.
$
The door may be left crooked if the hinges are not mounted
properly.
Reclose the attachment levers (picture C). Close the oven
3.
door.
&
ã=
Risk of injuries.!
Do not touch the hinges; the door might accidentally fall or a
hinge might suddenly close. Notify the Technical Assistance
Service.
Removing the door covering
The oven door cover can change colour with time. For better
cleaning, we recommend removing the cover.
Fully open the oven door.
1.
Unscrew the oven door cover. To do this, unscrew the right
2.
and left hand side bolts (figure A).
%
%
Remove the cover (figure B).
3.
$
Ensure that the oven door does not close when the cover is
not in place. The inside glass may damage.
Clean the surface using a product specifically for cleaning
stainless steel.
Refit and secure it.
4.
Close the oven door.
5.
Fitting and removing the glass panels
The glass panels of the oven door can be removed to make
cleaning easier.
When removing the inner glass panels, take note of the order of
disassembling. To replace the glass panels in the correct order,
refer to the codes that appear on the panels.
Removing
Unhook the oven door and position it on a cloth with its
1.
handle pointing downwards.
Unscrew the upper oven door cover. To do this, unscrew the
2.
right and left hand side bolts (figure A).
Lift and remove the top glass panel (figure B).
3.
$
Unscrew the clips from the right and left and remove them
4.
(figure C).
Remove the glass panel.
&
Tilt and remove the lower glass upwards.
5.
Clean the glass panels using a glass cleaning product and a
soft cloth.
Do not use abrasive or corrosive cleaning products, glass
scrapers, or hard metal scourers as these could damage the
glass.
%
%
11
Advertisement
Table of Contents
