Installation Instructions; Unpack Refrigerator; Reduce Tipping Radius - Thermador KBULT3651A Installation Instructions Manual

INSTALLATION INSTRUCTIONS

U n p ack R e f r i g e ra to r
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when
not completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or
serious injury.
IMPORTANT:
Do not remove the protective film until the refrigerator is in its
operating position.
All 4 leveling legs must contact the floor to support and
stabilize the full weight of the refrigerator.
Keep the cardboard shipping piece or plywood under the
refrigerator until it is installed in the operating position.
1. Remove and save the literature package and parts bag taped
to the refrigerator door. Remove the 4 brackets (2 on each
side) that attach the shipping base to the refrigerator bottom.
NOTE: Do not remove tape and door bracing until the
refrigerator is in its final position.
2. Place an appliance dolly under the freezer side of the
refrigerator. Be sure to protect the side trims and handles.
Place the corner posts from the packing materials over the
trims and handles as appropriate. Carefully tighten the strap.
NOTE: Pass the dolly strap under the handles for the Curved
and Professional Series.
3. Place pieces of the shipping carton on the floor when rolling
the dolly and refrigerator into the house. Move the refrigerator
close to the built-in opening.
R e d u c e T i p p i n g R a d i u s
( i f req ui r e d )
Before bringing the refrigerator into the home, be sure there is
adequate ceiling height to stand the refrigerator upright. See
"Tipping Radius" in the "Design Specifications" section for more
information.
If you do not have adequate ceiling height to stand the
refrigerator upright, the tipping radius can be reduced by
removing the top grille and side trims (see the following chart).
Model
36 in. (91.4 cm)
Custom Panel Series
1. Grasp both ends of the top grille.
2. Push the top grille straight up; then pull straight out. Lay the
grille on a soft surface.
2
1. Top grille
2. Cabinet side trim
3. Remove the 6 screws attaching each cabinet side trim to the
refrigerator and remove the side trims.
4. Stand the refrigerator up. First, place the left bottom edge of
the refrigerator on the floor, stand the refrigerator upright, and
then lower the right-hand side of the refrigerator to the floor.
5. Reassemble the trim and top grille after the dolly has been
removed from the refrigerator.
Curved Handle and Professional Handle Series
1. Grasp both ends of the top grille. Push the top grille straight
up; then pull straight out. Lay the top grille on a soft surface.
2
1. Top grille
2. Cabinet side trim
2. Remove the 6 screws attaching each cabinet side trim to the
refrigerator and remove the side trims.
Reduced Tipping Radius
in. (223.5 cm)
1 2
1 2
15