Drive Chain Housing - Yamaha Vector RS90GTA Owner's Manual

RS90GT / RS90LTGT / RST90GT
1
1. Left lower cover
14. Install the drive guard, and then install the
left side cover and the shroud (RS90GT /
RS90LTGT / RST90GT), or close the
shroud (RST90).
ESU13922

Drive chain housing

To check the drive chain housing oil
level
1. Place the snowmobile on a level surface
and apply the parking brake.
2. Remove the shroud and the right side
cover (RS90GT /
RST90GT), or open the shroud (RST90).
[See page 63 (RS90GT / RS90LTGT /
RST90GT) or page 67 (RST90) for the
procedures.]
3. Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
RS90GT / RS90LTGT / RST90GT
1. Dipstick
Periodic maintenance and adjustment
RS90LTGT /
1
RST90
1. Dipstick
4. Remove the dipstick and check that the
oil is between the maximum and mini-
mum level marks on the "REVERSE"
side of the dipstick. If the oil is below the
minimum level mark, add sufficient oil of
the recommended type to raise it to the
maximum level mark. NOTICE: Make
sure that no foreign material enters
the drive chain housing.
1. Maximum level mark
2. Minimum level mark
[ECS00531]
91