Removing And Installing The Shroud And Covers (Rs90Gt / Rs90Ltgt / Rst90Gt) - Yamaha Vector RS90GTA Owner's Manual

ECS00940
NOTICE
Be sure to slide the covers onto the
G
short end of each hexagon wrench be-
fore placing the wrenches in the tool kit.
Securely tie the strap around the tool kit.
G
3
1
1. Hexagon wrench cover
2. Hexagon wrench
3. Tool kit
4. Strap
ESU14142
Removing and installing the
shroud and covers (RS90GT /
RS90LTGT / RST90GT)
EWS00091
WARNING
Be sure shroud and covers are secured
before operation. A loose shroud or cover
could move and cause loss of control.
Shroud
To remove the shroud
Loosen the fasteners, slowly raise the shroud,
and then unhook the shroud from the shroud
stay.
Periodic maintenance and adjustment
2
4
1
1. Fastener
2. Shroud
3. Shroud stay
To install the shroud
Hook the end of the shroud onto the shroud
stay, slowly lower it to the original position,
and then tighten the fasteners.
1. Shroud stay
Left and right side covers
To remove a side cover
1. Remove the shroud. (See the above pro-
cedure.)
2. Loosen the fasteners, pull outward on the
areas shown, and then slide the side cov-
er forward to remove it.
2
3
63