Table of Contents
Advertisement
Setting the CLOCK
The unit can set the clock function in power on/off state.
1 1
Press CLOCK.
(If the clock is requires setting, press and hold
CLOCK for more than 2 seconds.)
- The hours begin to blink.
.
2 2
Select a 12 hour cycle or 24 hour cycle by
turning MULTI JOG DUAL CONTROL.
(12HR)
3 3
Press SET to confirm the selected hour cycle.
Sleep Function
When the sleep timer is used, the power is automatically turned off after the specified time has elapsed.
1 1
To specify the time delay before the power is
turned off, press SLEEP.
In the display window you can see
about 5 seconds. This means that the system
turns off automatically after 90 minutes.
Each time the button is pressed the time interval
before it turns off is reduced by 10 minutes. i.e.
80...70... etc.
Select the desired time to turn off.
Using Microphone (OPTIONAL)
You can sing to a music source by connecting a
microphone to the unit.
1 1
Connect your microphone (not supplied) to the
MIC socket.
2 2
Play a music you want.
3 3
Sing along with the accompaniment.
Adjust the microphone volume by turning MIC
VOLUME KNOB.
or
(24HR)
for
4 4
Use MULTI JOG DUAL CONTROL to set the
correct hours.
5 5
Press SET.
.
6 6
Use MULTI JOG DUAL CONTROL to set the
correct minutes.
7 7
Press SET and the correct time is shown on
the display.
8 8
Press CLOCK at any time to display the time
for about 5 seconds.
2 2
To check the remaining time until the power is
turned off.
While the sleep function is active press SLEEP
briefly. The time remaining until it turns off is dis-
played for about 5 seconds.
Note
If you press SLEEP while the sleep time is displayed,
the SLEEP time is reset.
To cancel the sleep timer mode
If you wish to stop the function, press the SLEEP button
repeatedly until 10 appears, and then press SLEEP
once again while 10 is displayed.
For your reference
You can record during using microphone.
Refer to the "Recording" explanation section.
Notes
• When not using the microphone, set the MIC volume
knob to minimum or turn off the MIC and remove the
microphone from the MIC socket.
• If the microphone is set too near the speaker, a
howling sound may be produced. In this case, move
the microphone away from the speaker or decrease
the sound level by using the MIC volume control.
• If sound through the microphone is extremely loud, it
may be distorted. In this case, turn the MIC volume
control toward minimum.
9
Advertisement
Table of Contents
