Novation Xio User Manual page 21

Whilst in the Effects Menu, you can move to another Effect simply by selecting it with the Effect Select
buttons shown in the diagram above. For example, to access the Reverb parameters from the Delay Menu,
press the downward Effect Select button so that the Reverb LED lights. Now, use the page up/down buttons
next to the LCD screen to cycle through the following pages:
REV Type – sets the type of Reverb between: Chamber, S-Room (Small Room), L-Room (Large Room), S-Hall
(Small Hall), L-Hall (Large Hall), G-Hall (Giant Hall)
REV Decay Time – sets the amount of time taken for the Reverb to decay
To view the Chorus parameters, press the downward Effect Select button once more so that the Chorus
LED is active. Once in the Chorus (Effects) Menu, use the page up/down buttons next to the LCD screen
to cycle through the following pages, using the data encoder to change the settings for each page:
CHOR Type – selects either CHORUS or PHASER mode
CHOR Mod Rate – sets the rate of Chorus modulation
CHOR Mod Depth – sets the amount of Chorus modulation
CHOR Centre Posn – shifts the centre point of the Chorus modulation between either extreme (dependent
on the previous Depth setting)
CHOR Feedback – sets the amount of Feedback. It is normally advisable to have low levels of feedback when
in Chorus mode and higher levels in Phaser mode
CHOR Init Posn – sets the Chorus start point to Left, Right, Middle or Off (where there is no defined
start point)
To view the Distortion parameters, press the downward Effect Select button once more so that the Distort
LED is active. Once in the Distortion (Effects) Menu, use the page up/down buttons next to the LCD screen
to cycle through the following pages, using the data encoder to change the settings for each page:
DIST Compensate – compensates for/decreases the level overload caused by the Distortion
DIST Output Lvl – compensation can cause the overall level to be low so this page allows the level to
be increased
To view the EQ/Vol parameters, press the downward Effect Select button once more so that the EQ/Vol
LED is active. Once in the EQ/Vol (Effects) Menu, use the page up/down buttons next to the LCD screen
to cycle through the following pages, using the data encoder to change the settings for each page:
EQ Mid – increases/decreases the level of Mid Frequencies
EQ Treble – increases/decreases the level of High Frequencies