Replacing The Lamp - Taxan U6-112 User Manual

Warning: Lamp
compartment is hot!
Allow it to cool down
before changing
lamp!
Warning: To reduce
the risk of personal
injury, do not drop
the lamp module
or touch the lamp
bulb. The bulb
may shatter and
cause injury if it is
dropped.
English English 36 36
Appendices

Replacing the lamp

The projector will detect the lamp life itself. It will show you a
warning message
When you see this message, change the lamp as soon as
possible.
Make sure the projector has been cooled down for at least 30
minutes before changing the lamp.
1
2
Lamp Replacing Procedure:
1. Turn off the projector by pressing the Power/Standby
button.
2. Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the 2 screws from the cover.
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module.
7. Pull out the lamp module. 
To replace the lamp module, reverse the previous steps.
3
4