Sony FD Trinitron WEGA KV-32FS13 Operating Instructions Manual page 16

TV, VCR, and Cable Box
Use this connection if you subscribe to a cable system that scrambles
some channels (pay channels), but not all of them. This set up allows you
to use the remote control to:
a) change channels through your cable box or VCR when you are
receiving a scrambled signal, and
b) change channels through your TV.
This connection also allows you to use the PIP feature when you are
viewing unscrambled channels coming directly into your TV from your
cable. Scrambled signals coming through the cable box cannot be viewed
in PIP. For more information on the PIP feature, see page 18.
Rear of TV
VIDEO IN
VCR __e
2b "d (y Ilow)
L__ _ _ AUddiO L _rV_h;tel
J
Cabl
1 Splitter ,.
Cable 2a
OptionaI connection
1
Connect the single input jack of the splitter to your incoming cable
connection.
2 Using a coaxial cable (not supplied), connect the two output jacks of
the splitter to:
a) the IN jack on your cable box, and
b) the VHF/UHF jack on the TV.
3 Using a coaxial cable (not supplied), connect the OUT jack on your
cable box to the IN jack on your VCR.
h'ontinued)
7