Table of Contents
Advertisement
Operation of Remote Controller
1
ON/OFF :
Press this button to turn on the
2
MODE :
Each time you press this button,a mode is selected in a sequence that goes from AUTO,
COOL, DRY, FAN,and HEAT
*Note: Only for models with heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
3
Press
this button to decrease set temperature. Hold it down for above 2 seconds to
rapidly decrease set temperature. In AUTO mode, set temperature is not adjustable.
+
:
4
Press this button to increase set temperature. Hold it down for above 2 seconds to
rapidly increase set temperature. In AUTO mode, set temperature is not adjustable.
5
FAN :
This button is used for setting fan speed in the sequence that goes from AUTO,
,
,
to
then back to Auto.
6
:
Press
button to start or stop up & down swing function.The remote controller
●
defaults to simple swing condition.
●
Press + button and
simple swing and static swing;
In static swing condition, pressing
●
changes as below:
●
If the unit is turned off during swing operation,the louver will stop at present position.
Remote controller description
unit.
Press this button again to turn off the unit.
*
, as the following:
AUTO
COOL
DRY
Auto
Low speed
button at the same time at unit OFF to switch between
*
FAN
HEAT
Medium speed
blinks for 2 seconds.
button, the swing angle of up & down louver
7
High speed
,
Advertisement
Table of Contents
