Troubleshooting - TECHWOOD CDC-85 Owner's Manual

TROUBLESHOOTING

To determine any problem with your CD changer, always check the most obvious possible causes first. If any problem still
remains after your have checked the items below, consult your nearest TECHWOOD dealer.
Problem
No power when the POWER button is
set to ON.
Disc play does not start.
No sound.
Sound skips.
Programmed play does not function.
A "Hum" sound can be heard.
No remote control functions.
Probable Cause
Power plug not connected in the AC
outlet.
The disc is loaded upside down.
The disc is too dirty.
Incorrect audio cable connections.
Incorrect amplifier operation.
The CD changer is subject to vibration
or physical shock.
Defective or deeply scratched disc.
The CD changer is in the normal play
mode.
Loose cable connections.
Remote cable is not connected to
changer and/ or receiver.
Changer is not being used with compatible
receiver.
13
Remedy
Insert the power plug firmly into the AC
outlet.
Reload the disc with the label side up.
Clear the disc.
Correctly connect the CD changer to
the amplifier.
Make sure that the amplifier controls
are set correctly.
Change the installation location.
Play another disc.
Press the stop button, then enter a pro-
gram.
Firmly connect all the cables.
Use supplied remote cable.
Remote functions only operate with
matching STR-84 or PLR-85 receivers.