Troubleshooting - TECHWOOD CDC86 Owner's Manual

TROUBLESHOOTING

To determine any problem with your CD changer, always check the most obvious possible causes first. If any problem still
remains after you have checked the items below, consult your nearest TECHWOOD dealer.
Problem
No power when the POWER button is
set to ON.
Disc play does not start.
No sound.
Sound skips.
Programmed play does not funct ion.
A "Hum" sound can be heard.
Probable Cause
Power plug not connected in the AC
outlet.
The disc is loaded upside down.
The disc is too dirty.
Incorrect audio cable connections.
Incorrect amplif ier operation.
The CD changer is subject to vibration
or physical shock.
Defective or deeply scratched disc.
The CD changer is in the normal play
mode.
Loose cable connections.
11
Remedy
Insert the power plug firmly i nto the AC
outlet.
Reload the disc with the label side up.
Clean the disc.
Correctly connect the CD changer to
the amplifier.
Make sure that the amplifier control s
are set correctly.
Change the installation locati on.
Play another disc.
Press the stop button, then enter a pro-
gram.
Firmly connect all the cables.