Connections - TECHWOOD CDC-85 Owner's Manual

CONNECTIONS

CAUTION : When you pull the plug out, make sure that the
unit has been turned to POWER STANDBY first.
Never disconnect the power with the unit on.
1. LINE OUT jacks
Connect these iacks to the CD input jacks on the amplifier :
White pin-plug White jack (left)
Red pin-plug Red jack (right)
White
L
R
Red
2. REMOTE CONTROL jacks
Connect the supplied remote control cable to the REMOTE
CONTROL jacks as shown in the above diagram, Connect
the other end of the cable to the rear of the matching STR-
84 or PLR-85 receiver. The remote control functions of this
tape deck will only operate when connected to a matching
Techwood STR-84 or PLR-85 receiver.
IMPORTANT :
A remote control is not included with this CD changer.
White White
L
R
Red Red
6
3. AC power cord
Plug this AC power cord into a 120 Volt, 60 cycle grounded
AC wall socket or the AC OUTLETS on the rear of the
STR-84 or PLR-85 receiver.