Time Display - TECHWOOD CDC-85 Owner's Manual

Erasing all the programmed contents
1. Press the program button.
2. Press the clear button and hold it for longer than 2 sec-
onds.
- All the programmed contents will be lost.
Note:
The Program button and the clear button can work only in
the stop mode.
* Changing the programmed contents
Deleting:
Undesired tracks can be deleted from the originally pro-
grammed contents.
1. Press the program button repeatedly until the track num-
ber that you want to delete appears on the display.
2. Press the clear button.
- Then that track number will be deleted from the pro
grammed contents.
If you press the button repeatedly, the next programmed
tracks will be deleted one by one each time the button is
pressed.
Adding after the last track:
1. Press the program button repeatedly until "END" appears
on the display.
2. Enter new tracks in the same way as normal programming
after "END" disappears from the display.
Adding to any position:
1. Select the program number which you want to add a new
track to by pressing the program button.
2. Enter the new track in the same way as normal
programming.

Time Display

Status of the display
This unit can display four types of time mode on the time
counter in the display.
1. The elapsed time of the current track is automatically
displayed when playback begins.
2. During playback, press the time button once and the time
remaining on the track is displayed.
3. Press the time button again and the total elapsed time of
the disc being played is displayed.
4. Press the time button once more and, the total remaining
time of the entire disc display will be displayed.
Notes:
Time will not be displayed during programmed play if the
programmed contents exceed 100 minutes. In this case,
"--,--" will be shown instead.
If you press the time button in the stop mode, the total
track number and the total playing time of the current disc
will be displayed.
When track 33 or more is played. the remaining time will
not be displayed.
11