Test Tone - TECHWOOD DDR 94 Owner's Manual

Test Tone

3
1
4
1 4
2
1
2
3
SKIP
SURROUND
STEREO MODE
TEST
C.LEVEL
TONE
NIGHT DIGIT AL
MODE INPUT
DDR 94
SLEEP
LEVEL
SELECT
4
2
REPEA T DISC SKIP
R.LEVEL
SUB W.
C.LEVEL
LEVEL
DELAY
R.LEVEL
CENTER REAR
MASTER
VOLUME
MUTING
ADJUST
Balancing relative volume between speakers
The test tone function is useful to adjust the relative volume
between speakers in DTS, DOLBY DIGITAL or DOLBY PRO
LOGIC mode.
Once the balance is set, you don't have to change the
balance as long as the speakers aren't moved.
1
Press the TEST TONE button in DTS, Dolby Digital or Dolby
PRO LOGIC mode.
The test tone is emitted from each speaker in the following
order at 2-second intervals.
2
Adjust the master volume to the normal listening level.
3 Adjust the volume of center and rear speakers so that the
test tone from each speakers sounds same.
Select a speaker by pressing the LEVEL SELECT button, and
adjust the level by pressing the ADJUST button (b /5 ), or
adjust the channel level directly by pressing the remote
contral unit (Center, Rear, Subwoofer : b /5 ).
< The level of rear, center and subwoofer can be adjusted in 1
dB steps from -10 dB to +10 dB.
4 When the setting is finished, press the TEST TONE button to
stop the test tone.
Note :
< If certain speakers are not being used, (for example, no
center speaker) the noise sequencer will automatically skip
over that channel.
< Press the LEVEL SELECT, ADJUST button for more than 5
seconds to reset the level to its original setting.
22