Video Operations; Playing Video Sources; Tape Dubbing; System Function - TECHWOOD DDR 94 Owner's Manual

Video Operations

Playing Video Sources

Note:
When playing videos that feature surround sound, refer to
"Available Surround Modes".
1
Select the VCR/VIDEO 1, TV/VIDEO 2, AUX/VIDEO 3 or
DVD/CD mode by turning the FUNCTION selector.
2
Play the component corresponding to the FUNCTION
selected.
3 The picture from the video source can be seen on the TV
and the sound from the video source will be heard from the
speakers.
Video Camera Connections
VCR, Video Camera Recorder, etc.
Connect the video camera recorder's AUDIO OUTPUT
to the AUDIO (L)/(R) jacks and VIDEO OUT to the VIDEO
jack of the AUX/VIDEO 3 INPUT.

Tape dubbing

Tape Dubbing
(from TV/VIDEO 2, AUX/VIDEO 3 or DVD/CD to VCR/VIDEO 1)
1
Turn the FUNCTION (source) selector to select the VIDEO
source (TV/VIDEO 2, AUX/VIDEO 3 or DVD/CD) to be
recorded.
2 Play back the source (TV/VIDEO 2, AUX/VIDEO 3 or
DVD/CD).
3 Operate VCR/VIDEO 1 for recording.
Video/audio signals from the selected VIDEO source can be
dubbed to VCR/VIDEO 1 only.
Note:
< When tape dubbing is performed, be sure to connect the
VCR/VIDEO 1 OUT (analog audio output).
< You cannot record video tapes from DVD discs.
S.A.V.E. (Second Audio Source for Video Editing)
System
This feature lets you replace the sound from a VCR with
sound from an AUDIO source such as CD during video signal
dubbing.
1
Select the video source (TV/VIDEO 2, AUX/VIDEO 3 or
DVD/CD) by turning the FUNCTION selector. Wait for more
than 5 seconds and then select the audio source with the
FUNCTION selector.
2 Operate the selected video component and audio
component for playback, respectively.
3 Now you can watch the picture from the video component
on the TV, and listen to the sound from the audio component
through the speakers.
4 Operate VCR/VIDEO 1 for recording.
16