Manual Memory Presetting; Direct Tuning - TECHWOOD DDR 94 Owner's Manual

Radio Reception

Manual Memory Presetting

1
1 Select the TUNER mode by turning the FUNCTION
selector.
2 Select the AM or FM by pressing the BAND selector
button.
3 Press the MODE(TUNING) button to change the tuning
mode from preset to manual.
The PRESET CH. indicator disappears from the display.
4 Select the frequency you want to preset by pressing the
PRESET button.
5 Press the MEMORY button briefly.
6 While the "MEMO" indicator is lit, select a preset
channel to store the station using the PRESET buttons,
and then press the MEMORY button.
To store more stations, repeat steps
2
4 6 5 6
3
4 to 6 .
15

Direct Tuning

FM: 100 kHz steps
AM: 10 kHz steps
Ex.: FM 107.5 MHz
Ex.: AM 1000 kHz
Using this method, the required frequency is input directly,
using the numeric keys on the remote control unit.
1 Press the TUNER button.
2 Select the AM or FM by pressing the BAND selector
button.
3 Press the DIRECT TUNING button on the remote control
unit.
''DIRECT IN'' appears on the display for a few seconds.
''FM---.--MHz'' or ''AM----kHz'' appears on the display.
4 Input the frequency of the broadcast you want to hear
with the numeric keys.
< If you press the DIRECT TUNING button again or without
pressing any button for 30 seconds, Direct tuning is
released.