In Case Of Trouble; Demo Mode; Resetting The Microprocessor - Pioneer DEH-P6200BT Operation Manual

Please contact the dealer or distributor from
where you purchased this unit for after sales
service (including warranty conditions) or any
other information. In case the necessary infor
mation is not available, please contact the
companies listed below:
Please do not ship your unit to the companies
at the addresses listed below for repair without
advance contact.
U.S.A.
Pioneer Electronics (USA) Inc.
CUSTOMER SUPPORT DIVISION
P.O. Box 1760
Long Beach, CA 90801 1760
800 421 1404
CANADA
Pioneer Electronics of Canada, Inc.
CUSTOMER SATISFACTION DEPARTMENT
300 Allstate Parkway
Markham, Ontario L3R 0P2
1 877 283 5901
905 479 4411
For warranty information please see the Lim
ited Warranty sheet included with this unit.
Should this unit fail to operate properly, please
contact your dealer or nearest authorized
PIONEER Service Station.
! Learn about product updates (such as firm
ware updates) for your product.
! Register your product to receive notices
about product updates and to safeguard
purchase details in our files in the event of
loss or theft.
! Access owner's manuals, spare parts infor
mation, service information, and much
more.
Important
Failure to connect the red lead (ACC) of this unit
to a terminal coupled with ignition switch on/off
operations may lead to battery drain.
The demo automatically starts when the igni
tion switch is set to ACC or ON while the unit
is turned off. Turning off the unit does not can
cel demo mode. To cancel the demo mode,
press / / . Press
again to start. Operating the demo while the
ignition switch is set to ACC may drain battery
power.
The microprocessor must be reset in the fol
lowing situations:
! Before using this unit for the first time after
installation
! If the unit fails to operate properly
! When strange or incorrect messages ap
pear on the display
01
/ /
5
En