Getting Started - Axxera AXD430 Installation & Owner's Manual

Please read entire manual before installation.
Before You Start
• D isconnect negative battery terminal. Consult a qualified technician for instructions.
• A void installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

• Remove trim ring from unit.
• Remove 2 transit screws located on top of the unit.
• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting
sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold
separately).
• Test for correct operation and slide into mounting sleeve to secure.
• Snap trim ring into place.
REMOVAL
HEAD UNIT
TYPICAL DIN FRONT-LOAD MOUNTING METHOD
Preparation
KEYS
AXD430
OPTIONAL REAR
MOUNTING SUPPORT
MOUNTING SLEEVE
2