JVC KD-R306 Instructions Manual page 69

ENGLISH
ELECTRICAL CONNECTIONS
A
Typical connections /
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious
damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
Rear line out (see diagram
Antenna terminal
White with black stripe White
Left speaker (front)
* 1
Not supplied for this unit.
* 2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise the
power cannot be turned on.
) Rear ground terminal
15 A fuse
15 A
Black
* 2
Yellow
* 2
Red
Blue
Blue with white stripe
Gray with black stripe Gray
Right speaker (front)
1
2
3
To the metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
12 V
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
Green with black stripe Green
Left speaker (rear)
*
1
*
2
3
Ignition switch
Fuse block
250 mA
200 mA
Purple with black stripe Purple
Right speaker (rear)