JVC KD-R306 Instructions Manual page 68

INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
Removing the unit
Before removing the unit, release the rear section.
When using the optional stay /
Fire wall
Dashboard
Install the unit at an angle of less than 30˚.
* 1
When you stand the unit, be careful not to damage the fuse on the rear.
* 2
Not supplied for this unit.
When installing the unit without using the sleeve /
In a Toyota car for example, first remove the car radio and install the unit in its place.
TOYOTA
Stay (option)
Screw (option)
Note :
When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are used, they
30˚
could damage the unit.
•
Do the required electrical connections.
For KD-R306/KD-R305 /
KD-R306/KD-R305
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
Flat head screws (M5 × 8 mm) *
2
*
2
M5 × 8 mm
* 2
Bracket
*
2
Pocket
8 mm
*
1
*
2
2
Bend the appropriate tabs to hold the
sleeve firmly in place.
Flat head screws (M5 × 8 mm)
M5 × 8 mm
* 2
Bracket
*
2
JVC
* 2
*
2