JVC KD-R306 Instructions Manual page 34

Category Menu items
MONO *
3
Monaural mode
IF BAND
Intermediate
frequency band
FADER* 4
Fader
BALANCE
Balance
LOUD
Loudness
AUX ADJUST
Auxiliary input
level adjustment
BEEP
Keypress tone
AMP GAIN *
5
Amplifier gain
control
AM *
6
AM station
AUX IN *
7
Auxiliary input
* 3 Displayed only when the source is "FM."
* If you are using a two-speaker system, set the fader level to "00."
4
* The volume level automatically changes to "VOLUME 30" if you change to "LOW POWER" with the volume level
5
set higher than "VOLUME 30."
*
6 Displayed only when any source other than "AM" is selected.
*
7 Displayed only when any source other than "AUX IN" is selected.
14 SETTINGS
Selectable settings, [reference page]
• MONO ON : Activate monaural mode to improve FM reception, but stereo
effect will be lost, [8].
• MONO OFF : Restore the stereo effect.
• AUTO : Increases the tuner selectivity to reduce interference noises
between adjacent stations. (Stereo effect may be lost.)
• WIDE : Subject to interference noises from adjacent stations, but
sound quality will not be degraded and the stereo effect will
remain.
R06 – F06 : Adjust the front and rear speaker output balance.
[Initial: 00]
L06 – R06 : Adjust the left and right speaker output balance.
[Initial: 00]
• LOUD OFF : Cancels.
• LOUD ON : Boost low and high frequencies to produce a well-balanced
sound at a low volume level.
AUX ADJ 00 : Adjust the auxiliary input level to avoid the sudden increase
— AUX ADJ 05 of the output level when changing the source to external
component connected to the AUX input jack on the control
panel.
• BEEP OFF : Deactivates the keypress tone.
• BEEP ON : Activates the keypress tone.
• LOW POWER : VOLUME 00 – VOLUME 30 (Select if the maximum power
of each speaker is less than 50 W to prevent damaging the
speaker.)
• HIGH POWER : VOLUME 00 – VOLUME 50
• AM OFF : Disable "AM" in source selection.
• AM ON : Enable "AM" in source selection, [4].
• AUX OFF : Disable "AUX IN" in source selection.
• AUX ON : Enable "AUX IN" in source selection, [4].