Rear Panel Connections; Video Connections - Tascam AV-452 Installation & Support Manual

5 – Rear panel connections
This section provides detailed information on the rear
panel connectors, as well as some notes on installa-
tion and connection of other units.

Video connections

Video connections
All video connections on the AV-452 switch in paral-
lel. There is no conversion between composite and
S-Video signals. In some designs, you may need to
connect both video formats to the source decks.
This also means that the AV-452 is standard-indepen-
dent and can accept NTSC, PAL or SECAM format
video with no configuration needed.
In addition to these connectors, remember that there
is an additional video connector on the front
AUX
D
panel .
L M N
12
TASCAM AV-452 Installation & Support Guide
Basic specifications and performance figures are pro-
vided later in the manual.
"Master" audio
connections
5
6 6
4
ON DIP
7
3
2 8
9
1 1 2 3 4 5 6
0
External control connectors
NOTE
All connectors on the rear panel are labeled relative to
the AV-452. In other words, a connector labeled IN on
the AV-452 should be connected to one marked OUT on
another piece of equipment.
L RGB2 THRU connector
sub connector echoes the signal input at the front
panel input
M DVD IN connectors
tors is used to connect the video output of a DVD
player to the AV-452.
O
N VCR IN and OUT connectors
the video output of a videocassette recorder to the
VCR IN
OUT
O MONITOR OUT connectors
connectors to the appropriate input of a TV, monitor
or projector.
AV audio & microphone
connections
K
.
, and the video input of the VCR to the
.
This 15-pin D-
This pair of connec-
Connect
VCR
Link these