Table of Contents
Advertisement
heater and to ensure proper jet performance. Follow the heater
manufacturer's instructions for installing and adjusting the
bypass system. (NOTE: A bypass system may enhance jet
performance even if the heater's flow capacity rating is sufficient
according to the above specifications.
Typical Bypass Plumbing for External Gas
(Consult Heater Owner's Manual for Specific Instructions)
Installing the Sentry Control Panel
If the equipment system is being installed in a location away
from the spa, the control panel cable should be installed in a
conduit to provide protection for the cable and make it
convenient to remove should it ever need servicing or
replacement.
Cut or drill an appropriate size hole where the control panel is to
be mounted and install the conduit from this point to a point
under the control box of the equipment system. Using a fish tape
or similar means, carefully pull the cable through the conduit.
Then feed the plug through an opening on the bottom of the
control box (Ill. 1, item 5) and plug the connector into the
daughter board on the inside right wall of the control box (Ill. 1,
item 8). Finally, peel the backing from the adhesive on the back
of the control panel, align the panel in the position desired and
press firmly.
Connecting the Spa Light
Your Sundance Spa Shell comes equipped with a dry-niche, low-
voltage spa light installed. The cable from this light should be
run through the opening provided in the bottom of the control
10
Ill. 6
Heater
11
Hide quick links:
Advertisement
Table of Contents
