Functions That Cannot Be Set Or Will; Not Work Under Some Conditions - Panasonic LUMIX DMC-FZ28 Operating Instructions Manual

[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there are no remaining folder numbers that can be used.
•
(P116)
> Format the card after saving necessary data on a PC etc.
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P29)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
The AV cable is connected to the camera.
•
> Press [MENU/SET] if you want to delete this message at once.
> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect.
This message also appears when the USB connection cable is connected to the camera only.
•
In this case, connect the other end of the USB connection cable to a PC or a printer. (P115,
117)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
The printer cannot print.
•
> Check the printer.
Functions that cannot be set or will not work
under some conditions
Due to the camera's specifications, it may not be possible to set some of the functions or
some functions may not work in some of the conditions under which the camera is used.
The table below lists these functions and the corresponding conditions.
For the functions which cannot be set or will not work in the Intelligent auto mode, refer to
•
Settings in Intelligent auto mode
"
Functions that cannot be set
or will not work
[AUTO POWER LCD]/
High angle mode
[HISTOGRAM] (P47)
[POWER SAVE] (P28)
[AUTO LCD OFF]
[AUTO REVIEW] (P29)
(P36).
"
Main conditions in which the functions cannot be set or will not
( mode
•
(P27)
$ mode
•
[CALENDAR]
•
When using the AC adaptor
•
When connecting to a PC or a printer
•
When recording or playing back motion pictures
•
During a slide show
•
[AUTO DEMO]
•
(P28) When using the AC adaptor
•
While the menu screen is displayed
•
While the self-timer is set
•
While recording motion pictures
•
When connecting to a PC or a printer
•
$ mode
•
(P30) If you execute
work
Others
(P30)
133
VQT1S48