P [Protect] - Panasonic LUMIX DMC-FZ28 Operating Instructions Manual

Advanced (Playback)
Depending on the photo printing store or the printer, the date may not be printed even if you set
•
to print the date. For further information, ask at your photo printing store or refer to the
operating instructions for the printer.
The date cannot be printed on pictures stamped with text.
•
Note
The number of prints can be set from 0 to 999.
•
With a printer supporting PictBridge, the date print settings of the printer may take precedence
•
so check if this is the case.
It may not be possible to use the DPOF print settings with other equipment. In this case, cancel
•
all the settings, and reset the settings.
If the file is not based on the DCF standard, the DPOF print setting cannot be set.
•
You can set protection for pictures you do not want to be deleted by mistake.
Select [PROTECT] on the [PLAYBACK] mode menu.
Press 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
Select the picture, and then press
[MENU/SET].
When [MULTI] has been selected
Repeat these steps for each picture.
•
The settings are cancelled when [MENU/
•
SET] is pressed again.
Press [‚] to return to the menu screen.
Press [MENU/SET] to close the menu.
•
∫ Cancelling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step
2 Press 3 to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
If you press [MENU/SET] while cancelling protection, the cancelling will stop halfway.
•
Note
The protect setting may not be effective on other equipment.
•
Even if you protect pictures in the built-in memory or a card, they will be deleted if the built-in
•
memory or the card is formatted.
Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, they
•
cannot be deleted when the card's Write-Protect switch is set to [LOCK].
112
VQT1S48

P [PROTECT]

[SINGLE]
Press 2/1 to
select the picture.
2
(P23)
Press 3/4/2/1
to select the
pictures.
and then press [MENU/SET].
[MULTI]