Panasonic LUMIX DMC-FZ28 Operating Instructions Manual page 132

Others
[NOT ENOUGH SPACE ON BUILT-IN MEMORY]/[NOT ENOUGH MEMORY ON THE
CARD]
There is no space left on the built-in memory or the card.
•
When you copy pictures from the built-in memory to the card (batch copy), the pictures are
–
copied until the capacity of the card becomes full.
[SOME PICTURES CANNOT BE COPIED]/[COPY COULD NOT BE COMPLETED]
The following pictures cannot be copied.
•
When a picture with the same name as the picture to be copied exists in the copy
–
destination. (Only when copying from a card to the built-in memory.)
Files not based on the DCF standard.
–
Moreover, pictures recorded or edited by other equipment may not be copied.
•
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
This message will be displayed when you formatted the built-in memory on a PC.
•
> Format the built-in memory on the camera again.
will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
This card has a format which is not recognised by the camera.
•
> Format the card again with the camera after saving necessary data on a PC etc.
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]
This message will be displayed when the lens does not operate properly because force was
•
applied by hand, or if the lens hood is not attached securely.
> Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Centre.
[MEMORY CARD PARAMETER ERROR]
> Use a card compatible with this unit.
You can only use an SDHC Memory Card if using cards with 4 GB or more capacity.
•
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
An error has occurred accessing the card.
•
> Insert the card again.
Or try with a different card.
•
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
An error has occurred reading or writing the data.
•
> Turn the camera off and remove the card. Insert the card again and turn the camera on.
Make sure the camera is turned off before removing or inserting the card to avoid
damage.
Or try with a different card.
•
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
When you set the picture quality to [
•
card with "10MB/s" or greater displayed on the package.
Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording
•
may stop in the middle.
132
VQT1S48
(P30)
(P20)
], [ ] or [ ], we recommend using a high-speed
The data on the built-in memory
(P30)