Wolf CT15I Installation Instructions Manual page 9

I N S TA L L AT I O N I N S T R U C T I O N S
C O O K T O P I N S TA L L AT I O N
L O C AT I N G U N I T I N C O U N T E R T O P
Attach the foam strip to the underside of the
cooktop frame. Refer to the illustration below.
Gently lower the unit into the cut-out area in
the countertop and center. Check that the front
edge of cooktop is parallel to the front edge of
the countertop. Check that all required clear-
ances are met.
Attach the brackets to the bottom of the unit,
as shown in the illustration below. Install the
clamping screws into the bracket and tighten
until screws contact the underside of the
counter top. Do not overtighten screws.
IMPORTANT NOTE: Do not use caulk or
silicone to seal the unit to the countertop. The
unit must be readily removable for service.
COOKTOP
FOAM
STRIP
Foam strip
B E F O R E O P E R AT I N G
Clean the glass surface carefully using Cooktop
Cleaning Crème provided with the product.
Remove all cleaner residues.
Read the entire Wolf Induction Cooktop Use &
Care Information included with the cooktop.
Important safety, service and warranty infor-
mation is contained within the book.
If the cooktop glass is broken, turn off
power to the unit. Do not operate until
the glass has been replaced by a Wolf
Factory Authorized Service Center
technician.
COOKTOP
COUNTERTOP
BRACKET
1
3 / "
BRACKET 2 (89)
SCREWS CLAMPING
SCREW
Installation brackets
T H E C O O K T O P
9