Wolf CT15I Installation Instructions Manual page 4

W O L F
S I T E
IMPORTANT NOTE: Installation of the Wolf
induction cooktop must meet the following
location requirements. All dimensions listed
are minimum requirements for safe operation.
To eliminate the risk of burns or fire by
reaching over heated surface units,
cabinet storage space located above the
surface units should be avoided. If
cabinet storage is to be provided, the risk
can be reduced by installing a ventilation
hood that protects horizontally a
minimum of 5" (127) beyond the bottom
of the cabinets.
F
G
Minimum clearances for installation
4
I N D U C T I O N C O O K TO P
P R E P A R A T I O N
D
H
E
A
B
L O C A T I O N I N C O U N T E R T O P
A) Minimum flat countertop surface. Must be
equal to or greater than cooktop width.
B) Minimum 2" (51) wide clearance from the
cooktop side edge to any combustible
surface up to 18" (457) above the cooktop
(noted by shaded area).
C) Minimum 2" (51) wide clearance from the
cooktop side edge to any combustible
surface up to 18" (457) above the cooktop
(noted by shaded area).
O V E R H E A D C A B I N E T D I M E N S I O N S
D) Minimum spacing between cabinets directly
over cooktop must be greater than or equal
to the nominal width of the cooktop unit(s).
E) Minimum 18" (457) vertical distance from
the countertop surface to the bottom of
cabinets adjacent to the cabinet directly
above the cooktop unit.
F) Minimum 24" (610) clearance between top
of cooking surface and bottom of wood or
metal cabinet which is protected by not less
than 1/4" (6) flame retardant millboard
covered with not less than No. 28 MSG
sheet steel, .015" (.4) stainless steel, or .024"
(.6) aluminum or .02" (.5) copper. Minimum
30" (762) clearance between the top of the
cooking surface and the bottom of an
C
unprotected wood or metal cabinet.
G) Minimum 0" (0) from rear wall.
H) Maximum 13" (330) depth of overhead
cabinets.
Failure to locate the cooktop unit
without the proper clearances will result
in a fire hazard.