Wolf CT15I Installation Instructions Manual page 8

W O L F
E L E C T R I C A L
Verify that power is disconnected from
the junction box before proceeding.
Required Power Supply
240 V AC / 18 amp / 60 Hz – 20 amp service
Maximum Connected Load
3.6 Kw at 240 V AC
Operating Voltage Range
207 V AC – 250 V AC
The Wolf induction cooktop requires a
separate, grounded 3-wire service with its own
circuit breaker. Locate electrical within the
shaded area shown in the Installation Specifi-
cations illustration on page 5.
This appliance must be installed in accordance
with National Electrical Codes, as well as all
state, municipal and local codes. The correct
voltage, frequency and amperage must be
supplied to the appliance from a dedicated,
grounded circuit which is protected by a
properly sized circuit breaker or time delay
fuse. The proper voltage, frequency and
amperage ratings are listed on the product
model / serial rating plate, located on the
underside of the cooktop.
8
I N D U C T I O N C O O K TO P
R E Q U I R E M E N T S
The cooktop is provided with a 4' (1.2 m)
conduit consisting of two insulated hot lead
conductors (copper) and one insulated ground
conductor (copper).
For Electrical Installation – attach the
conductors to the residence wiring in accor-
dance with National Electrical Codes and all
state, provincial, municipal and local codes.
The complete appliance must be properly
grounded at all times when electrical
power is applied.
Do not ground the appliance with the
neutral (white) house supply wire. A
separate ground wire must be utilized.
If aluminum house supply wiring is
utilized, splice the appliance copper wire
to the aluminum house wiring using
special connectors designed and agency
certified for joining copper and
aluminum. Follow the connector manu-
facturer's recommended procedure care-
fully. Improper connection can result in a
fire hazard!
Dimensions in parentheses are in
millimeters unless otherwise specified.