Batteries - Strong SRT L 300 User Manual

3" lcd tv
Table of Contents

Advertisement

PART 1 • English

BATTERIES

IN THE REMOTE CONTROL
Insert the CR2025 type battery (3 V) in the battery compartment into the remote control (the polarity "+" on top) then push the
n
battery compartment into the remote control
Do not:
Place near or expose to flame
n
Take apart or short circuit
n
Attempt to recharge alkaline or manganese battery
n
Use battery if the covering has been peeled off
n
Mishandling of battery can cause electrolyte leakage which can damage items and may cause a fire
n
If electrolyte leaks from the battery, consult your dealer. Wash thoroughly with water if electrolyte comes in contact with any part
n
of your body
Remove Battery if the remote control is not going to be used for a long period of time. Store in a cool, dark place
n
Replace Battery if the unit does not respond to the remote control even when held close to the front panel
n
USING THE REMOTE CONTROL
Aim at the sensor, avoiding obstacles, at a maximum range of 7 m (23 feet) directly in front of the unit
n
Keep the transmission window and the unit's sensor free from dust
n
Operation can be affected by strong light sources, such as direct sunlight, and the glass doors
n
on cabinets
Do not:
Put heavy objects on the remote control
n
Take the remote control apart
n
Spill liquids onto the remote control
n
HANDHELD TV
The HANDHELD TV allows playing without any AC power
n
CHARGING METHODS
This unit contains a built-in rechargeable battery. When the battery LED lights in red, the battery will stop supplying power to the system.
Then you need to charge the battery. Please follow the steps below. You can watch the TV and recharge the battery simultaneously.
1. Connect the unit to the external power source via AC/DC power adapter or car cigarette lighter adapter. You can refer to the
diagram below and to the next page.
2. When the battery is being charged, the battery LED will glow red.
3. The battery LED will turn green after the battery is full.
4. Charge your battery for a minimum of 4 hours to get fully charged.
Remote control signal sensor
Battery LED
7

Advertisement

Table of Contents
loading

Table of Contents