Advertisement
3. Select in the Menu of your receiver the field that shows you the signal level
indicators. (Normally you can find the signal meter in the Channel Scan field
of the menu).
4. Now optimise the signal strength by finding the best position for the antenna.
Keep the antenna in your hand, try to reach the highest possible position.
Now slowly turn the antenna around it's axis (in the horizontal field), at the
same time monitor the signal bars in the menu, once the signal indicator
shows the maximum signal, fix the antenna on that position.
5. It is important to place the antenna in such way that an acceptable signal
level is assured. You can optimise the signal strength by moving the antenna
to different locations in your room, for example place it near a window, or
place it on a high placed book-shelf. The best position can be found by trying
different locations.
NOTE:
It is recommended NOT to place the antenna near to:
Devices that are strong source of radiation or interference such as DECT and
n
GSM telephones, Transmitters, Microwaves, etc.
Devices with high power consumption such as Electrical Heater, Air conditioner,
n
Hairdryers, etc.
* If you can not find this option in the Menu of your Digital Terrestrial Receiver, please
check in your user manual if your receiver supports active antenna power (5 Volts DC via
the RF cable). If you are not sure; please contact your dealer.
In case this option is not supported by your Digital Receiver you need to connect a external
power supply to power the antenna. Ask your electronic dealer for an external 230 V AC to
DC power adapter that supplies 9 Volts DC, 100 mA. Note that the + and the – of the power
adaptor are located as follows:
The connector for the external power supply can be found at
the backside of the antenna.
NOTE:
T he antenna will not function properly if the build-in amplifier is not powered.
Therefore it is required to supply the antenna with power via the RF cable or via a
external adapter.
Extension of the RF cable:
In some cases you may need to extend the standard supplied RF cable, we advise you to
only do this if you can not get a optimal signal strength within the reach of the standard
cable. If you are to extend the RF cable, then please note following comments:
Use a good quality RF cable, 75 Ohm type only with proper shielding
n
Use well shielded connectors, your dealer can advise you on this
n
Make sure that both inner cable and shielding are properly connected to the connectors
n
to assure active antenna power supply and to avoid short circuit in the cable
If you extend the cable, please keep the cable as short as strictly needed. Extending the
cable or using bad quality cable will reduce the performance of your antenna.
Subject to alterations. In consequence of continuous research and development technical specifications,
design and appearance of products may change. All product names are trademarks or registered
trademarks of their respective owners.
© STRONG 2009. All rights reserved. 06/2009
4
PART 1 • English
Advertisement
