Programming Scan Memory; Memory Scanning ( M-Scan ); Priority Scanning ( P-Scan ) - Standard Horizon HX290 Owner's Manual

6.9.2 PROGRAMMING SCAN MEMORY

1. Turn the transceiver off by rotating the VOL knob fully
counter-clockwise.
2. Hold down the
while still holding down the
3. " " will appear on the display, indicating the Menu
("Set") Mode has been activated.
4. Press the
Menu item "
5. Press the
scanned, then press the
pears on the display, which indicates the channel has
been selected to the scan channel.
6. Repeat step 5 for all the desired channels to be pro-
grammed into scan memory.
7. To DELETE a channel from the list, select the channel
then press the
the display.
8. When you have completed programming the scan memory, turn the trans-
ceiver off and on by rotating the VOL knob.

6.9.3 MEMORY SCANNING ( M-SCAN )

1. Adjust the SQL level until background noise is eliminated by pressing the
key followed by the
2. Press the
grammed into scan memory and preset channels.
The "SCN" icon will appear at the left of the channel num-
ber on the display during scanning.
3. When the HX290 receives a transmission, it will stop on the channel until
signal disappears, then start scanning again.
4. To stop the scan, press the

6.9.4 PRIORITY SCANNING ( P-SCAN )

1. Adjust the SQL level until background noise is eliminated by pressing the
key followed by the
2. To start scanning, press the
the highest programmed channel and the Priority Chan-
nel (Channel 16). The "PRI" and "SCN" icons will appear
at the left of the channel number on the display during
scanning.
3. When the HX290 receives a transmission on a working channel, it will stop
Page 24
key, and then turn on the transceiver
key, repeatedly if necessary to select the
".
or key to select desired channel to be
key. The "SCN" icon disappears from
or
key to start scanning channels pro-
or
key.
key. The "SCN" icon ap-
key.
key briefly.
key.
key. The scan proceeds from the lowest to
HX290