Memory Scan; Programming Scan Memory; Operation - Standard Horizon hx380 Owner's Manual

6.8 MEMORY SCAN

The HX380 will automatically scan channels programmed into Preset Channel
Memory and also channels store into Scan Memory.
When an incoming signal is detected on one of the channels during scan, the
radio will pause on that channel, allowing you to listen to the incoming trans-
mission. The radio will automatically start scanning again after the transmis-
sion stops.

6.8.1 PROGRAMMING SCAN MEMORY

1. Turn the transceiver off by rotating the VOL knob fully counter-clockwise.
2. Hold down the
down the
3. Press the
the key.
4. Press the
scanned, then press the
on the display, which indicates the channel has been
selected to the scan channel.
5. Repeat step 4 for all the desired channels to be pro-
grammed into scan memory.
6. To DELETE a channel from the list, select the channel
then press the
the display.
7. When you have completed programming the scan mem-
ory, press the
press the

6.8.2 OPERATION

1. Press the
/ key until the background noise disappears.
2. Press the
grammed into memory and preset channels. " MSCAN "
will be shown in the upper left corner of the display.
3. When the HX380 receives a transmission, it will stop on
the channel until the incoming signal disappears, then
start scanning again.
4. To stop scanning, press the
Page 24
key, and then turn on the transceiver while still holding
key.
or key to select " MEM CH " and press
or key to select desired channel to be
key. The "
key. The "
key to save your changes, and then
key to exit to normal operation.
key to activate the squelch adjusting mode, then press the
key to start scanning channels pro-
" icon appears
" icon disappears from
key.
HX380