Advertisement
Powering by STB or Digital TV
Indoor
STB or Digital TV
If your receiver does not support 5 V antenna power, then please follow the next steps:
B. To power the antenna with external power adaptor:
1. Switch OFF your receiver and disconnect it from the 230 V mains power.
2. Take the short Coaxial (IEC male to IEC female) Cable. Connect the IEC Male
end to your Set Top Box. Normally the input connector on your receiver is
marked as "ANT" (in) or as "RF" (in). Refer to the User Manual of your Digital
Terrestrial Receiver.
3. Connect the other end of the cable to the connector on the power injector that
is marked as "Receiver".
4. Take the supplied "long" coaxial cable and connect the end with the "F
connector" (screw type connector) to the antenna. Carefully press the inner
lead of the cable into the Female-F connector at the back of the antenna. Turn
the covering nut clockwise with your HANDS until it is fixed.
5. Connect the other side of the cable to the connector at the power injector, it is
marked as "Antenna".
6. Insert the adapter to the 230 V mains power and insert the connector at the
end of the lead to the power injector - it is marked as "DC 9 - 12 V".
7. Proceed to chapter 5. "Installation of the antenna".
4
Coaxial Cable
PART 1 • English
Outdoor
Water-Drop Loop
(recommended)
Advertisement
