[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
Use a card with SD Speed Class
¢ SD Speed Class is the speed standard regarding continuous writing.
•
In the event that it stops even after using a "Class 6" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P28).
•
Depending on the type of the card, motion picture recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
(P135)
> Format the card after saving necessary data on a PC etc.
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P26)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
•
The AV cable is connected to the camera.
> Press [MENU/SET] if you want to delete this message at once.
> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect.
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P133,
136)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
•
The printer cannot print.
> Check the printer.
[NO BATTERY POWER REMAINS]
•
The remaining battery power is low.
> Charge the battery.
[THIS BATTERY CANNOT BE USED]
•
The battery cannot be recognised by the camera.
> Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Centre.
•
The battery cannot be recognised as its terminal is dirty.
> Remove any dirt etc. from the terminal.
Others
¢
with "Class 6" or higher when recording motion pictures.
- 160 -
(P28)
If you execute
(P27)