Easy Cassette Eject; Hand Strap; Lens Cap - Panasonic PV-DV102 Operating Instructions Manual

Easy Cassette Eject/Insertion
• If the Palmcorder is connected to a power
source, the cassette can be inserted and
ejected without turning the Palmcorder
on.
4
PUSH
CLOSE
1
LCD-OPEN
Cassette Compartment
Cover
Note
• When inserting the cassette, make sure it is facing the right direction and then push it
in completely.
Attaching the Shoulder Strap
1
Undo the two strap ends
from their buckles.
2
Thread the strap ends
through the Strap
Attachment Rings.
3
Reinsert the strap ends through their
buckles.
• Make sure the straps
are not twisted.
Adjust the Length
1
Loosen the strap from the Buckle and
create a loop.
2
Pull the strap firmly through the
Buckle to shorten or lengthen the
strap.
DV102.p 5-9.p65
Before you begin
• Connect the Palmcorder to a power
source. (pp. 13, 14)
1
Press LCD-OPEN to unlock the LCD
2
monitor, and swing it fully open.
TAPE EJECT
2
Slide TAPE EJECT to open the
Cassette Compartment Cover.
3
Insert a cassette record tab up,
window side facing out.
4
Press PUSH CLOSE to close the
Cassette Compartment Cover.
• To remove the cassette...
Slide TAPE EJECT to open the Cassette
Compartment Cover and pull the cassette
tape straight out.

Hand Strap

Adjust the length of the Hand Strap to the
size of your hand as illustrated.
Hand Strap

Lens Cap

Attaching the Lens Cap Strap:
Thread the Lens Cap Strap through the
Strap Attachment Ring as shown.
2
3 1
Attaching the Lens Cap Cord to the Hand
Strap:
Remove the Hand Strap from the front
clasp and thread the Strap through the loop
in the Lens Cap Cord.
Reattach the Hand Strap.
1
7
Before Using
1 2
3
02/03/05, 12:55
7