Replace The Battery - Panasonic PV-DV102 Operating Instructions Manual

Replace the Battery

Optional
A
B
+
Replace battery with Panasonic PART NO. VSBW0004 (CR2025) only. Use of another battery may
present a risk of fire or explosion.
Caution: battery may explode if mistreated. Dispose of used battery properly. Keep away from
children. Do not recharge, disassemble or dispose of in a fire.
Remote Controlling Two
Palmcorders
You can control any two Panasonic
Palmcorders with one Remote control
(Optional). In order for the remote to
distinguish between the two units, it is
necessary to set one of the Palmcorders to
VCR 2. On the remote, press VCR 1 or
VCR 2 to control the desired Palmcorder.
Optional
For VCR 2:
Press these
buttons at the
same time.
Note
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE
(REMOTE)" will appear.
DV102.p 5-9.p65
1
Insert a slender pointed object, such as the tip of a ball-
point pen into the slot so that it fits into the hole (as shown
A). Then, while sliding to the right, pull the Battery Tray out
with your fingernail.
2
Insert the battery into the Battery Tray with the
facing down.
Do not reverse the polarity.
3
Insert the Battery Tray.
1
Set POWER to VCR or CAMERA.
• The POWER Lamp lights red.
• Be sure POWER is fully turned to
VCR or CAMERA position.
2
Press MENU to display the VCR or
CAMERA mode menu screen.
3
Rotate JOG KEY to select
the CAMERA mode menu screen or
PLAY MODE
screen, then press JOG KEY to
display the CAMERA SET-UP or VCR
PLAY MODE menu screen.
For VCR 1:
4
Press these
Rotate JOG KEY to select
buttons at the
and then press JOG KEY to select
same time.
VCR 2. (Menu OSD: pp. 105, 106).
Leave the other Palmcorder set to
VCR1.
5
Set the Remote Control (Optional) to
VCR 1 or VCR 2 to correspond with
the Palmcorder you wish to control.
(See above left.)
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
9
Before Using
+
mark
SET-UP
in the VCR mode menu
REMOTE
02/03/05, 12:56
in
,
9