Charging The Battery - Panasonic LUMIX DMC-FT1 Operating Instructions Manual

Preparation

Charging the Battery

∫ About batteries that you can use with this unit
The battery that can be used with this unit is DMW-BCF10E.
It has been found that counterfeit battery packs which look very similar to the
genuine product are made available to purchase in some markets. Some of these
battery packs are not adequately protected with internal protection to meet the
requirements of appropriate safety standards. There is a possibility that these
battery packs may lead to fire or explosion. Please be advised that we are not
liable for any accident or failure occurring as a result of use of a counterfeit
battery pack. To ensure that safe products are used we would recommend that a
genuine Panasonic battery pack is used.
•
Use the dedicated charger and battery.
•
This unit has a function that can distinguish useable batteries. Exclusive batteries
(DMW-BCF10E) are supported by this function. (Conventional batteries not supported
by this function cannot be used)
•
The battery is not charged when the camera is shipped. Charge the battery before use.
•
Charge the battery with the charger indoors.
•
Charge the battery in a temperature between 10 oC to 35 oC. (The battery temperature should
also be the same.)
Attach the battery with
attention to the direction of the
battery.
Connect the AC mains lead.
•
The AC mains lead does not fit entirely
into the AC input terminal. A gap will
remain as shown below.
•
Charging starts when the [CHARGE]
indicator A lights green.
•
Charging is complete when the
[CHARGE] indicator A turns off (after
approx. 130 min maximum).
Detach the battery after
charging is completed.
Preparation
17
VQT1Z56