Operation - Central Pneumatic 94802 Assembly And Operating Instructions Manual

Note: Performance of the compressor (if powered by line voltage) may vary
depending on variations in local line voltage. Extension cord usage may also affect
tool performance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
When unpacking, check to make sure the parts listed on page 8 are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
Impact
Wrench
For best service you should incorporate an oiler, regulator, and inline filter, as shown in the
diagram above. Hoses, couplers, oilers, regulators, and filters are all available at Harbor
Freight Tools.
1. You will need to prepare a
on the Impact Wrench. First, wrap the
before threading it into the Inlet (31). Connect the
connect coupler (not included), and then to the Impact Wrench.
Note: If you are not using an automatic oiler system, before operation, add a few drops
of Pneumatic Tool Oil to the airline connection. Add a few drops more after each hour
of continual use.
2. Set the air pressure on the regulator to 90 PSI. Do not exceed the recommended
air pressure of 90 PSI.
3. Check the air connection for leaks. Disconnect from the air source.
SKU 94802 For technical questions, please call 1-800-444-3353
Unpacking

Operation

1
/ " air connector (not included) to connect to the Inlet (31)
4
1
/ " air connector with pipe thread seal tape
4
3
/ " ID Air Source Hose to a quick
8
Page 4